Hello All,

Iam new to the openRisc world.

Can i use the 'NEW OpenRISC System-on-Chip FPGA development board' for connecting to the J2 to an ADC chip which delivers 16bit of dat with a sample frequency of 125 mhz.

Can i create a software program which will run ontop of the virtual processor which is able to get the data and does the ddc (Digital Down Conversion ) and send the data to the ethernet.

Programming in another application program (like c) rather than in verilog; is this achievable?

Where to find a good starting point about application programming?

Looking forward to your replies.

Johan