Dawson, Jon

TCP/IP socket

Command '$chips2/c2verilog precompiled/server.v' is not working.  Returns an error: at line 167 Expected: ;, got: server

I think I need to run this command in order to compile the IP stack into a Verilog module.  Correct?

c2verilog not working

Hi,

I tried to port your design to KC705 board equipped with 10Gb/s Ethernet.
That required implementation of the interface compatible ten_gigabit_ethernet.vhd controller which replaced yur original gigabite_ethernet.vhd controller.
All sources, which I used to build the project are available at:
http://www.ise.pw.edu.pl/~wzab/c2c_demo_kc705.zip

Of course the 10Gb/s link is not fully utilized by the C2C generated cores,
but it was just an experimental solution.
I hope that you, or someone else will find it useful.

With best regards,
Wojtek

Browse

TCP/IP socket