USB FPGA Module 1.11

Description

The ZTEX USB-FPGA-Module 1.11 is a Spartan 6 FPGA board with USB 2.0 interface, 64 MB DDR-SDRAM and Flash memory.

Features

• High-Speed (480 MBit/s) USB interface via Mini-USB connector (B-type)
• Cypress CY7C68013A EZ-USB-Microcontroller
• Xilinx Spartan 6 XC6SLX9, XC6SLX16 or XC6SLX25 FPGA
• 90 General Purpose I/O's (GPIO):
  • 82 FPGA GPIO's
  • 8 EZ-USB FX2 GPIO's
• 15 special I/O's (SIO):
  • 4 pins for FPGA configuration via JTAG
  • 2 pins for 1 serial ports
  • 2 pins I²C interface (2 pins)
  • 2 interrupt pins
  • 3 timers
  • 1 Wakeup pin
  • 1 Breakpoint pin
• 64 MByte DDR SDRAM:
  • 200 MHz clock frequency
  • 16 Bit bus width
  • Up to 800 MByte/s data rate
  • Easy to use hard memory controller included Spartan 6 FPGA with 6 ports. (examples included in SDK)
• MicroSD socket for standard and high capacity (SDHC) microSD cards (the cards must support the SPI mode)
• 128 Kbit EEPROM memory (can be used to to store the firmware)
• FPGA configuration via USB (no JTAG adapters or other additional utilities required) or from Flash memeory

Images

Spartan 6 USB-FPGA-Module 1.11 from ZTEX. Click on the image for a larger version.

Block diagram of Spartan 6 USB-FPGA-Module 1.11 from ZTEX

References

• Product Homepage
• ZTEX Wiki
• Schematics (PDF)